| FSBB20CH60C | - 600 V - 20 A 3-Phase IGBT Inverter with Integral Gate Drivers and
Protection
- Low-Loss, Short-Circuit Rated IGBTs
- Very Low Thermal Resistance Using Al2O3 DBC Substrate
- Built-in Bootstrap Diodes and Dedicated Vs Pins Simplify PCB Layout
- Separate Open-Emitter Pins from Low-Side IGBTs for Three-Phase
Current Sensing
- Single-Grounded Power Supply
- Isolation Rating: 2500 Vrms / min.
| Motion Control - Home Appliance / Industrial Motor | 600 V - 20 A IGBT inverter for three-phase DC / AC power conversion | - For inverter high-side IGBTs: gate drive circuit, high-voltage
isolated high-speed level shifting control circuit, Under-Voltage
Lock-Out Protection (UVLO)
- For inverter low-side IGBTs: gate drive circuit, Short-Circuit
Protection (SCP) control supply circuit, Under-Voltage Lock-Out
Protection (UVLO)
- Fault signaling: corresponding to UVLO (low-side supply) and SC
faults
- Input interface: active-HIGH interface, works with 3.3 / 5 V logic,
Schmitt-trigger input
| - VPN Supply Voltage: 450 V
- VPN(Surge) Supply Voltage (Surge): 500 V
- VCES Collector - Emitter Voltage: 600 V
- IC Each IGBT Collector Current (TC = 25C, TJ 150C): 20 A
- ICP Each IGBT Collector Current (Peak) (TC = 25C, TJ 150C, Under 1
ms Pulse Width): 40 A
- PC Collector Dissipation (TC = 25C per Chip): 62 W
- TJ Operating Junction Temperature: -40 ~ 150 C
| - VCC Control Supply Voltage: 20 V
- VBS High-Side Control Bias Voltage: 20 V
- VIN Input Signal Voltage: -0.3 ~ VCC + 0.3 V
- VFO Fault Output Supply Voltage: -0.3 ~ VCC + 0.3 V
- IFO Fault Output Current: 5 mA
- VSC Current-Sensing Input Voltage: -0.3 ~ VCC + 0.3 V
| - VRRM Maximum Repetitive Reverse Voltage: 600 V
- IF Forward Current (TC = 25C, TJ 150C): 0.5 A
- IFP Forward Current (Peak) (TC = 25C, TJ 150C, Under 1 ms Pulse
Width): 2.0 A
- TJ Operating: (Not specified)
|